- SMOOTHSTEPPER ERROR ON MACH3 CNC WINDOWS 10 PDF
- SMOOTHSTEPPER ERROR ON MACH3 CNC WINDOWS 10 FULL
- SMOOTHSTEPPER ERROR ON MACH3 CNC WINDOWS 10 FREE
Data may be saved to a CSV file (CMM like measurement recording) or to a DXF to build up CAD file of probed geometry. All of the routines provide dimensional measurement info (CMM like usage) and the option to zero the axis to probed features (setup). The XY Probing page provides several canned routines that probe sides, corners, edges, ID bores, slots, etc. In addition, you must be able to center your spindle to the gauge ring BEFORE running the option 2 calibration routine to get the correct offsets measured.
This method is less ideal, as you must re-install the probe at the same angle everytime. If your probe tip has mechanical runout, use option 2 to create a calibration table that includes an X/Y offset for the tip to shank error.
If your probe tip is mechanically centered to the shank (Prefered!), then run option 1 to create a table that compensates for tip deflections and backlash. You can select from two methods of calibration depending on your probe. The compensation can correct for probe trip deflections, backlash, etc and results in the ability to probe parts and perimeters very accurately. The probe routine builds a table of ‘compensated tip diameters’ for every 10 degree angle directions. When you create a calibration table, you probe the ID of an accurate and round ‘gauge ring’ that you provide the actual measured inner diameter. The Calibration and Setup page is where you set some of the basic parameters, and have the option of creating a probe tip calibration table. It serves one simple yet important purpose… Test your probe out and verify the big LED on the Mach3 screen lights up when you activate the tip before you do any probing! This verifies your probe hardware, wiring, and Mach3 port/pin setup! The introduction page is the default page that Probe-It opens to.
SMOOTHSTEPPER ERROR ON MACH3 CNC WINDOWS 10 PDF
Please review the HELP page to download a copy of the manual in PDF format, and to see some of the basic requirements to run Probe-It. Probe-It! doesn’t include other probing features already existing or available, for example the 3D ‘bed of nails’ approach which is in a Wizard shipped with Mach3, is not found in Probe-It!. The goal of Probe-It is to provide a useful tool with functionality I couldn’t find anywhere else.
SMOOTHSTEPPER ERROR ON MACH3 CNC WINDOWS 10 FULL
Option 2 builds a full correction table that then accounts for the ‘offset’ in the probe tip to the shank/spindle center line. Mode 2: If your probe has runout, or is non-adjustable, you can manually locate the spindle to the center of the ring gauge (use DTI, co-ax indicator, etc) before calibrating with option 2.